There are two methods of entering commands. The most common method is to press ~ to bring up the console. Alternatively, you can use the chat window to enter commands. To do this, type the desired command with "##" directly preceeding it. Example: ##DebugMode 1

Note that commands are case sensitive. Many will also ask you to select a target. For those commands which ask for a target, you can click on either the character or, in the case of party members, the character's portrait. And finally, remember that you have to enable debug mode before you can use console commands. The game will acknowledge any properly entered commands but will not actually carry them out if debug mode is not enabled.







These commands were found on GameFAQs. I merely rearranged them and posted them here for convenience.

Alternative means of inputting commands:

Originally posted by spateneder:

Console Commands can also be inputed, by writing the command in the chat and adding ##. For example ##DebugMode 1 .

Instant Kill, Teleportation and other commands

Originally posted by Zwerkules:

Once you activated DebugMode you can destroy or kill just about anything by placing the mouse pointer on it and pressing either crtl+z or ctrl+y depending on your keyboard layout.

Originally posted by Zwerkules:

also should add the dm_jumptopoint x y command. ( get stuck running up ramps sometimes it helps). while in DebugMode move your cursor to where you wan to be and press x on the keyboard( will give you your cordinates.

a full listing can be found at ##http://nwn.wikia.com/wiki/Console_command## remove the ##:rfacepalm:

Originally posted by wogle:

Numpad plus teleports
Also, be careful with the insta-kill shortcut; if you target a held item, it destroys the item. To kill a creature make sure you're targetting its torso.

Clocking your FPS.

Originally posted by Calgacus:

Also if you are trying to get your frame rate you may want to use the "trace fps" command -- eg in the chat bar:
##trace fps

Chooser window and zone teleportation

Originally posted by Michael:

I don't think I saw this mentioned in your guide (unless my eyes are tired), but while in debug mode, you can hit the period key to bring up the "chooser" window. This lets you teleport to any zone in the game, interact with targets via the interface rather than commands, etc.

I'd also like to add that the chooser window offers additional ways to mess with targets - such as toggling invulnerability, taking direct control of npc's, etc.