https://cs2bus.com/sharedfiles/filedetails/?id=1716650742

Hi Rammy I just took a run of this scenario and I had no trouble zooming along at 45 mph.
So did you have your brakes fully off? Keys "P" and maybe "J" as well.
Did you close your cylinder co-cks, I notice that loco has them open at the start.
Did you reduce the reversing lever to about 20% once you got under way?
Gosh it's a touchy loco to shunt with
I will put up a screen shot showing my speed as well as Reversing lever and throttle settings.

Hi Rammy, its been ages since I played this, but will give it a go again and get back to you. {Maybe tomorrow}

Very Good Scenario, i ran out of water in expert mode, so Changed to Simple Controls but Struggled to get more than 20Mph out of Loco Any Advice would be Appreciated. i Don't Normally do Steam because i'm not Good. Thanks.

Hi ash, many thanks for your favourable comments.
I hope you enjoy parts 2 and 3.

Superb scenario, well done. Very enjoyable, thanks for sharing, part 2 & 3 next.

lol. Maybe I should have given the scenario another level of difficulty.

Now you tell me.

Yes especially coupling to that empty open wagon, I found opening the cylinder cocks and clicking the icon to allow uncoupling and setting brakes on wagons was a big help.

Terrific scenario shuntting work not easy Thank you BP