Hello 8vn1,

As you can see from the comments below I have had the same problem. But there is a solution.

Can you please tell me if you know how to make a Quick Drive Scenario?

this does not load, only route you get is paddington to oxford

Hi,

Thank you for providing me with that information on the issue. I will try and have an investigate later on if I get the chance.

Thomas

Hi,

If I go into Quick Drive and load a 390 I get a notice saying that it cannot load as it cannot find the destination Oxford 2. I then created a scenario from the existing scenario in Build at a different Paddington platform going to Oxford 1. I get the same notice. When creating a new scenario in Build from Oxford to Paddington I am told to check electrification and train type.

I have also done a complete uninstall/install of Train Sim (but that is not because of this).

Hope that helps!

Johnny

What scenario are you using please?

To add....

I created a scenario with a 390 from Oxford to Paddington. Loading the scenario I have " Invalid start point - Check Electrification and train type." I have no problem running a diesel locomotive on this electrified track.

"does not load properly anymore, just always says cannot find destination, is there a fix?"

Same with me loading the route from Quick Drive. But for me it has never worked.

But the Didcot Parkway electrification is loaded and works well and is really great.

Perhaps they should not be both subscribed at the same time?

Thank you for this really useful creations as it allows me to try every sort of train out of Paddington and go fast.

Please can you clarify where you experiencing the "cannot find destination" error

does not load properly anymore, just always says cannot find destination, is there a fix?

I'm unsure if I'll have time

yes

The whole line?

it is possble to do the crewe to holyhead elecified if you have the time

Just go in the editor and put a train down

Ye, on quick drive

Just make a scenario starting at Oxford?

please can you make it so i can start at oxford?

That's odd, but as I said there's not much I can do, are you using a quick drive?

Cygnet0115
Thanks for your reply, i did press tab and then got derailed just outside of Paddington

That’s not my route, that’s the default GWML signalling, try pressing TAB to request to pass at danger

Cygnet0115
Have downloaded your route but i couldn't get past the red light at the end of the platform at
Paddington but all the points were set okay?

AWSOME